1. Remove your drain strainer and place Drain-Net in drain.
2. Rotate the bolts out of the hexagon so that they are approximately equal in length and can easily fit into the drain.
Installation Instructions
3. Place the Lock and Stop™ in the drain using the provided installation tool.
4. Rotate the hexagon to extend the screws until they are pressed firmly against the inner wall of the pipe.
5. Tighten hexagon with wrench until the hole is aligned with the hole in your drain. If there is no hole in drain, drill one through the center so that the screw will fit.
6. Place drain strainer back over drain and insert the bolt through the center drain hole and into the hole in the hex bolt. The vertical bolt secures your drain to the cross member.
7. Tighten the Lock and Stop vertical bolt with the unique spanner bit we provide to lock your drain and stop others from accessing your drains.
Welcome to Drain-Net, your home for comprehensive
Drain, Waste, and Grease management solutions.
Drain, Waste, and Grease management solutions.
Content copyright 2009 Drain-Net. All rights reserved. Lock and Stop™ is a trade mark of Drain Net
www.drain-net.com | www.drain-tech.com
Site design by Imageway
www.drain-net.com | www.drain-tech.com
Site design by Imageway
